66-77 Bronco Winch Bumper | ProtoFab RockSolid Series

Description

The RockSolid bumper design makes it difficult for obstacles to trap. It is designed so that your truck slides upwards and onwards over any obstacle rather than catching. It will add protection and style to our classic RockSolid look. This bumper will fit almost any winch so long as it uses the standard mounting bolt pattern which is 10″ x 4.5″.

Easy bolt-on installation with no welding required however you will need to drill four 7/16″ holes IN YOUR BUMPER to install, so please test fit the bumper to the truck before you apply paint or powder coat so that you can drill the appropriate holes. You will use the holes in the front of your Bronco Frame as the mark for where the holes should be drilled. Drill a hole in the top and bottom of each side of the bumper frame mount.

Push Bar Styles

The Bull Bar: A single low-cut hoop in the center of the bumper made from 2″ 0.120 wall round tubing.

Pre-Runner: A taller center hoop with diagonal kicker tubes extending to the outside edges of the bumper. Made from 2″ 0.120 wall round tubing and 1 1/4″ side braces.

Edition

Tack Kit: A tack welded kit that arrives in its true form and will require several hours of welding and grinding to complete. It is not a flat kit and will not be more economical when shipping.

Welded: Arrives as unfinished raw-steel ready to install. We ALWAYS recommend test fitting the bumper to your truck BEFORE applying paint or powder coat. Once you have successfully mounted the bumper to your truck, it is safe to remove it and apply a finish.